User's Manual Cat. H140-E1-01 User's Manual H140-E1-01 Overview Preparations Basic Operations Operations for Applications Parameters Appendices Cat. H140-E1-01 Note: Specifications subject to change without notice. Authorized Distributor: 1005 OMRON Corporation Industrial Automation Company Control Devices Division H.Q. User setup mode 2 sec *1 Operator setup mode + 2 sec +2 sec Pressing the key will display the set temperature and output amount alternatively on the set value (SV) displaying unit.0 ~ 100. 0.Operation mode Manual reset Supplying in the power after finish wiring will display the current temperature. • Digital Temperature Controller series INSTRUCTION MANUAL HEAD OFFICE Thank you for purchasing HANYOUNG product. HANYOUNGNUX CO.,LTD Please check whether the product is exactly the same as you ordered. 1381-3, Juan-Dong, Nam-Gu Incheon, Korea, Before using the product, please read this instruction manual carefully. • █ Control Output Composition HX series is a multi-control-output temperature controller. It can have relay ON/OFF, SSR voltage pulse output, 4 – 20 mA current output as a control output by selecting an option in the parameter. If the option is chosen like below in the output parameter ( ) of the output group ( ) in standard temperature controller 0: Relay ON/OFF control is as a control output. • Operation Method Set value (SV) setting group █ When turn the power ON after completing wiring Available Symbol Parameter Option condition Default (1) After the firmware version of the temperature controller appears for a short period of time, the operation mode is running like the number ①. • Communication group Alarm type and code Available Pay atteontion in selecting relay type. Using inverse relay ( such as use nomally closed Symbol Parameter Option Default condition instead of nomally open) will not output anything even though the indicator is on. Communication Options for group. • In order to get better response against disturbance in the steady state, there is usually ② Please use the current transformer (CT) designed by Hanyoung NUX. A large overshoot in the transient state. To reduce this overshoot in the transient state, 2 ③. • Function 13: Factory reset function Function 11: Hysteresis type This function is used for parameter values to revert to initial setting values. According to selection of Hysteresis type in ON/OFF control, ON/OFF turning point is as follows: 1. Select factory reset function (PArA) in control group (G.CtL). Software free download sites. Ex) HYS.t: Cntr(center) 2. • ※ For the instructions of the protocol regarding communication, please refer to the 0311 PID group 1 integral time 0 ~ 6000 sec PID Group Hanyoung protocol instruction manual on Hanyoung Nux homepage(www.hynux.com). 0312 PID group 1 derivative time 0 ~ 6000 sec PID Group 0313 1.MR. • Appearance, Panel cutout and Connection Diagram (Units: ㎜) OUT1 OUT2 OUT1 OUT2 OUT1 OUT2 ● Appearance OUT1 ● Panel cutout ● Connection Diagram OUT1 OUT2 RTX(+) RELAY OUT1 RELAY RTX(-) OUT1 OUT1 RTX(+) SSR/SCR OUT1 OUT1 OUT2 RTX(+) RELAY OUT1 RTX(-) RELAY.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |